- Had gelcoat damage along bootstripe repaired and bootstripe repainted
- Had bottom painted with antifouling paint
- Repaired frozen seacocks
- Had deteriorated fuel hoses replaced
- Had propellor repitched from 18 to 16
- Replaced toilet
- Replaced galley and head faucets
- Replaced instrument bezel rings
- Replaced engine room hatch gasket
- Replaced door catches in v-berth storage
- Repaired loose fiberglass along bulkhead in head compartment
- Replaced hatch gasket
- Found and fixed freshwater system leak
- Repaired head compartment door latch
- Mounted fire extinguisher
- Replaced center windshield gasket
- Cleaned and repaired aft canvas and applied waterproofing
- Cleaned interior
- Cleaned exterior, including mold and mildew on flybridge
- Cleaned engine room, bilge, and keel
- Cleaned A/C filter
- Cleaned and scrubbed mildew from all curtains and fabric
- Removed cockpit coaming
- Bought new lines and fenders
- Replaced anchor rode and shackles
- Replaced missing screws in cockpit portside step and teak trim
- Replaced gaskets on cockpit hatches
- Tethered aft cockpit hatch
- Pumped out holding tank
- Removed name decal from transom
- Washed, polished, and waxed hull sides
- Touched up bottom-paint
- Checked all fuses and bought spares
- Duplicated ignition key
- Found key blanks for wheelhouse door key
- Duplicated wheelhouse door key
- Replaced prop nut zinc
- Changed oil and filter
- Changed crankcase breather
- Cleaned seawater strainer
- Changed transmission fluid
- Changed coolant/antifreeze
- Replaced air filter
- Replaced fuel filters and purged air from lines
- Winterized air conditioner
- Winterized fresh water system
- Winterized head/holding tank
- Checked battery water levels
- Drained seawater, circulated antifreeze through raw water system
- Replaced engine zincs
- Replaced coolant/antifreeze cap
- Replaced engine seawater intake hose and fixed chafe protection
- Serviced seacocks
- Repacked rudder stuffing box
- Repack shaft stuffing box
- Greased shift and throttle cables
- Greased steering cable
- Replaced A/C intake hose and plastic elbow fitting
- Cleaned engine, sanded and repainted rusted areas
- Cleaned corrosion from all brackets, bonding wires, engine mounts, etc, and sprayed with corrosion block
- Primed and painted rudder mounting brackets.
- Cleaned and assembled emergency tiller
- Re-bedded leaking stanchion bases
- Replaced batteries, battery cables, and battery switch
- Replaced all-round light with new combination masthead/all-round light
- Rewired Nav/Off/Anchor light switch for new light configuration
- Installed new stern light
- Repaired side navigation lights (upcoming shortly)
- Replaced flybridge compass
- Removed Loran and old VHF radio
- Removed Loran antenna and extra VHF antenna
- Installed new VHF with flybridge remote microphone
- Installed GPS (upcoming shortly)
- Installed blower
- Replaced stereo and corrected speaker wire runs
- Replaced galley and head outlets with GFCI outlets
- Replaced shorepower cable
- Replaced deteriorated electrical wire
- Replaced household wire nut connectors with heat-shrink butt connectors in bilge
- Rewired bilge pump directly to battery
- Added chafe protection for wire runs to cockpit
- Straightened and supported all electrical wire in engine room
These are things I still plan to do. By no means a comprehensive list...
- Reseal/regasket wheelhouse windows
- Replace main VHF antenna
- Replace hot water heater
- Replace port wiper motor
- Re-crimp battery cables
- Connect flybridge horn switch
- Caulk around galley and head sinks
- Maintain exterior teak
- Replace battery boxes
- Chafe protect lines
- Replace anchor locker latch
- Wash and wax top sides
No comments:
Post a Comment